Why is the Engine Management Light on?

If your car engine management light comes on, it will typically be illuminated in yellow. Whilst any dashboard warning light is cause for concern, those that illuminate in yellow or orange generally do so to inform the driver that a non-critical fault has emerged.

Engine Management Dashboard Warning Light
The engine management light is a common dashboard warning symbol

Essentially this means that there’s no immediate risk that vehicle safety is compromised or that vehicle electrical or mechanical components are likely to shortly fail.

However, if the engine management light illuminates in red, or flashes in red then this informing you of a more urgent problem. If driving, it would be advisable to pull over as soon as safe to do so, turn off the engine and investigate the problem further.

What Does the Engine Management Light Mean?

Due to vehicle manufacturers having varied technology and fault reporting, there is no single answer that can be given. However, the most common reasons for the engine management light to come on are as follows:

1. Exhaust Emissions

The car’s computer, the Electronic Control Unit (ECU) monitors various systems around the vehicle by use of sensors. The oxygen sensor checks for the correct fuel mixture via the amount of oxygen passing through the exhaust. The likely fault is here with the sensor itself which may need replacing, or the ECU reprogramming or updating. Though this isn’t an emergency, the chances are that your engine will be burning more fuel than necessary, which will of course reduce fuel economy. Have an engineer check your vehicle with a diagnostics tool.

2. Engine Misfire

Less common than the exhaust emissions fault above, but potentially more serious is an engine misfire. A misfire means that fuel has entered the combustion chamber but did not ignite. This unburned fuel must end up somewhere and this place is the exhaust. This can raise temperatures of a vehicle’s catalytic converter which may result in damage. All cars in the UK since 1993 have a catalytic converter which converts harmful gases such as carbon monoxide into less harmful gases such as carbon dioxide.

Catalytic converter warning light
Some vehicle models may use this specific symbol

Catalytic converters can be expensive to replace and a faulty one will fail and MOT emissions test, so if the engine management light is flashing or is red, slow down and ease off the accelerator until the flashing light stops. If the light remains on, pull over, turn off the engine to further investigate the issue. Some models of vehicle may use the engine management light or use a specific dashboard symbol if there’s an issue with the catalytic converter.

3. Blocked Particulate Filter

This only applies to diesel models. Some models of vehicle have a specific blocked diesel particulate filter warning light, whilst others will illuminate the engine management light. The particulate filter is fitted to diesel vehicles to help filter carcinogenic particles from the exhaust. A differential pressure sensor will trigger when the filter becomes clogged with particles and exhaust gasses struggle to pass through it. Once this occurs, diesel particulate filter (DPF) regeneration begins.

The process involves extra fuel being burned by the engine which heats up the DPF and in turn burns the deposits, therefore cleaning the filter. If this process fails, the engine management light comes on. If after driving consistently for 30 minutes or more and at a speed of 40 mph or ever and the light remains on, contact an engineer to have the issue diagnosed.

Diesel particulate filter warning light
Some vehicle models may use this specific symbol

4. Ignition System

If the engine management light (EML) comes on due to an ignition system fault, then the cause becomes a little more vague. You may experience engine misfiring, trouble starting, unexpected stalling and the vehicle may seem slower than usual. An ignition system fault may relate to anything from:

  • Ignition switch / wiring
  • Spark plugs
  • Glow plugs (if diesel)
  • Any wires or cables relating to the ignition system

5. Fuel Injection System

Fuel injection systems rarely go wrong, but on occasions they can become blocked resulting in an under performing engine, or one that doesn’t work at all. The fuel injection system relies of information from the ECU and if one of the various sensors around the vehicle trigger a fault, the EML will illuminate.

Engine Management Light on After Filling Up

The fuel tank is pressurised system with sensors and air valves that allow a specific amount of air back into the tank as the fuel is used. Over-filling your tank with fuel may trigger the EML or failure to secure the fuel cap properly. Check also the filler cap seal to ensure it’s in good condition. If the EML repeatedly comes on after filling up, it could be related to a valve or sensor.

Other Faults Relating to the Engine Management Light

  • Fuel pump
  • Mass airflow sensor
  • Transmission
  • Drive shaft
  • Vacuum hose

Diagnosing Engine Management Light Fault

As can be seen by the multitude of potential faults that the engine management light can cover, it’s almost impossible to diagnose the fault without specialist diagnostic equipment. Quite often however, slowing down, taking it steady or turning the car’s engine off and allowing it to rest will see the light go out.

Some vehicles may also have an additional information display that can provide further information on the fault or it may provide a specific fault code. If you have a car owners manual, further information on the fault, or fault code can often be obtained from this. If the EML stays on and wont go off, the only option is to take your car to a repair garage / engineer who will hook your vehicle up to diagnosis equipment.

Engine Management Light and the MOT

If you have an MOT scheduled and the engine management light is on, then there’s a possibility your car could fail the MOT if it’s related to the checks undertaken during the MOT process. The most common reason for the engine management light coming on is exhaust emissions. MOT tests involve strict emissions regulations, so it’s advisable to have the EML fault diagnosed and repaired before the MOT.

Engine Management Light Reset

Simply resetting the engine management light to make it go off without diagnosing the repairing the fault will result in the light coming back on again. However, if you have repaired the fault yourself and want to reset the symbol yourself, disconnecting the battery for a few minutes will work on certain vehicles. If this method doesn’t work, purchasing a diagnostic scanner and using the tool to reset the system should turn the symbol off.

5 thoughts on “Why is the Engine Management Light on?”

  1. heidi Bowman

    Good morning

    My Vauxhall aster management light has came on in yellow. A few days ago the car started ok but when I went into second gear it felt like it was slowing down and did cut out a few times.
    Any ideas to what thiS could be?, The car has had a full service and mot very recently.

    Kind regards Heidi Bowman

  2. Hello Heidi,
    The engine management light or ‘check engine’ warning light is a generic warning light that many potential faults associated to it. It could be something relatively simple such as a sensor, or something such as fuel injector or ignition system faults. The only way around it is to have diagnostic equipment hooked up which will read fault codes that are hopefully stored / generated. If the engine sounds rough and misfiring, you can damage the catalytic converter.

  3. William

    My Ford Mondeo TDi is a 2009 model with no cat so can’t understand why the check engine light was come on. Was serviced with new timing belt (expensive job) 6 months ago 101,300 Miles on the speedometer and only done 1000 miles since. Still running like a sewing machine. Will take it to the local garage who has been looking after the car for 7 years to get it checked over

  4. fergal reidy

    this light was coming on for 3 weeks…………….brought it to my local ford garage…………..2 hours work.got car back…………………….light was goone off…………….new filter nice man said……………24 hours later light back on………………………………………..what do i do now????

  5. Hi Fergal,
    Take it back as the garage clearly haven’t found out what the problem is. Perhaps they didn’t fit the air filter correctly or properly diagnose the fault in the first place. Seems as though the garage didn’t properly test and drive the vehicle after the repair and simply reset the fault code/s. Sometimes there may be a certain number of starting cycles before the fault is cleared, but it appears they reset it. I would take it back for a rescan.

Leave a Reply

Your email address will not be published. Required fields are marked *